Tennis Ball Broken Wall - 3" Ornament Sublimation Transfer

ORNAMENTS SUBLIMATION TRANSFERS

Temp: 385°-400°F | Pressure: Light | Heat Press Time: 150 seconds

1. Place the design face down on the ornament.

2. Use heat transfer tape to attach the paper to the ornament, with the design facing down. 

3. Use silicone mat and parchment paper/butcher paper on the top and bottom of the ornament to prevent bleeding.

4. Place the ornament on the heat press with the paper side up. Set the heat press to 385°-400°F and press for 150 seconds with light pressure. 

5.Immediately remove the paper and peel it hot.
Commercial Heat press is recommended

Sublimation Ornament can be used on:

Ceramic and Fiberboard Blank ornaments only designed for sublimation and heat-resistant.

You should only purchase products tagged as sublimation or that are compatible with sublimation.

You will receive a ready to press sublimation transfer. 

All prints are made on a professional sublimation printer which results in vibrant colors once applied CORRECTLY.

Your transfer will look faded when you receive it until pressed.

We are NOT responsible for transfers that are applied incorrectly or damaged during application.

Measure your mouse pad and adjusted/trim if may be necessary*

Also, note that colors will vary compared to this image mockup due to screen monitor.

All SUBLIMATION Transfers are FINAL SALE!

We do not accept returns or exchanges for any of our products. We are not responsible for any transfers that are pressed incorrectly. Make sure you are following application instructions.

@gcctransfers

Follow us on TikTok

@gcctransfers